5-21
Chapter 5 DISASSEMBLY OF BASIC ENGINE
4.7 Piston Pin and Piston - Remove
(1) Remove the snap ring with ring pliers.
(2) Place a piece of wood to piston pin end and lightly tap
with hammer to remove the piston pin, and separate the
piston from connecting rod.
Note:(a) Do not tap the piston pin directly with hammer.
(b) If the piston is stubborn, heat the piston with heater
or in hot water.
Piston Pin and Piston - Remove
4.8 Cylinder Liner Inside Diameter - Measure
Measure the cylinder liner inside diameter, and know the
current condition.
For the measurement procedure, refer to "Cylinder Liner
Inside Diameter - Measure" of "ASSEMBLY OF BASIC
ENGINE."
Cylinder Liner Inside Diameter - Measure
4.9 Cylinder Liner Flange Protrusion - Measure
Measure the cylinder liner flange protrusion, and know the
current condition.
For the measurement procedure, refer to "Cylinder Liner
Flange Protrusion - Measure" of "ASSEMBLY OF BASIC
ENGINE."
Cylinder Liner Flange Protrusion - Measure
4.10 Cylinder Liner - Remove
(1) Set the cylinder liner remover to the cylinder liner.
Note: Use care not to hit the piston cooling nozzle when set-
ting the remover plate to the bottom of cylinder liner.
(2) Screw the nuts, and remove the cylinder liner.
Cylinder Liner - Remove
Snap ring
Cylinder liner
Bolt
Cylinder liner flange
protrusion
Liner pusher
Cylinder liner flange
protrusion
Liner pusher
Cylinder liner
remover
P/N:32591-14100
Cylinder liner
Removing stroke
60 mm [2.36 in.]
Nut
To Next Page
Loading...
Need help?
General
