7-36
Chapter 7 ASSEMBLY OF BASIC ENGINE
5.16 Fuel Injection Nozzle Assembly - Install
(1) Apply a thin coat of grease to the gasket and install it to
fuel injection nozzle.
(2) Insert the fuel injection nozzle to the cylinder head, and
temporarily tighten the nozzle gland.
(3) Tighten the nozzle gland nut to the specified torque so
that the inlet connector of fuel injection nozzle does not
contact the valve spring.
Note: Do not forget to install the gasket when installing fuel
injection nozzle assembly.
Fuel Injection Nozzle - Install
5.17 Fuel pipe - Install
(1) Tighten the fuel injection pipe.
(2) Tighten the eyebolt of fuel leak-off pipe with the speci-
fied torque.
(3) Fix the fuel injection pipe and fuel leak-off pipe with a
clamp.
Fuel pipe - Install
Gasket
Nut
59 ± 2.9 N·m
{6 ± 0.3 kgf·m}
[43 ± 2.2 lbf·ft]
Eye bolt
Fuel leak off pipe
Fuel injection pipe
Nozzle gland
Sealing
washer
17.5 ± 2.5 N·m
{1.8 ± 0.3 kgf·m}
[12.9 ± 1.8 lbf·ft]
Clamp
Fuel injection pipe
Fuel leak off pipe
To Next Page
Loading...
Need help?
General
