Mitsubishi S12A2 User Manual

8-1
Chapter 8 FUEL SYSTEM
1. Fuel System - Remove and Inspect .......................................................................8-3
1.1 Fuel Injection Pipe - Remove and Inspect................................................................................ 8-3
1.2 Fuel Leak-off Pipe and Fuel Pipe - Remove and Inspect ......................................................... 8-4
1.3 Fuel Filter and Fuel Pipe - Remove and Inspect ...................................................................... 8-6
1.4 Stop Solenoid - Remove and Inspect ....................................................................................... 8-7
1.5 Fuel Control Link - Remove and Inspect .................................................................................. 8-9
1.6 Fuel Injection Pump - Remove and Inspect............................................................................ 8-12
2. Fuel System - Disassemble, Inspect and Assemble ..........................................8-14
2.1 Fuel Filter (Wire Element) - Disassemble, Inspect and Assemble.......................................... 8-14
2.2 Fuel Filter (Paper Element) - Disassemble, Inspect and Assemble ....................................... 8-15
2.3 Fuel Injection Nozzle - Disassemble and Inspect................................................................... 8-18
2.4 Fuel Injection Nozzle - Inspect and Adjust.............................................................................. 8-20
2.5 Fuel Injection Nozzle - Assemble ........................................................................................... 8-23
2.6 Fuel Injection Pump Accessory Drive - Disassemble and Inspect.......................................... 8-25
2.7 Outside Diameter and Inside Diameter of Accessory Drive Bearing Fit - Inspect .................. 8-26
2.8 Fuel Injection Pump Accessory Drive - Assemble.................................................................. 8-27
2.9 Governor Drive - Disassemble and Inspect............................................................................ 8-28
2.10 Outside Diameter and Inside Diameter of Bearing Fit ............................................................ 8-29
2.11 Governor Drive - Assemble ....................................................................................................8-31
3. Fuel System - Install..............................................................................................8-33
3.1 Fuel Injection Pump - Install ................................................................................................... 8-33
3.2 Fuel Control Link - Install........................................................................................................ 8-37
3.3 Stop Solenoid - Install............................................................................................................. 8-44

Mitsubishi S12A2 Specifications

General

Brand	Mitsubishi
Model	S12A2
Category	Engine
Language	English