5-16
Chapter 5 DISASSEMBLY OF BASIC ENGINE
3.4 Front Cover - Remove
(1) Screw two jack bolts evenly into the jack bolt holes,
and remove the front cover from the crankcase,
(2) Remove the oil seal (seal lip portion) from the front
cover.
(3) Remove the oil seal (slinger portion) from the crank-
shaft by tapping lightly or prying it.
Front Cover - Remove
When removing the oil seal (slinger portion), be careful
not to damage the crankshaft.If the crankshaft has a
flaw, oil will leak from its flaw even if new oil seal is
installed.
Jack bolt
(M10 × 1.5 mm)
Front cover
Oil seal
Bolt
Pointer
To Next Page
Loading...
Need help?
General
