5-7
Chapter 5 DISASSEMBLY OF BASIC ENGINE
1.10 Valve and Valve Spring - Remove
Using a valve spring pusher, compress the valve spring
evenly and remove the valve cotters.
Note: If valves are reusable, mark each valve seat and the
mating valve to identify their original positions. Do not
change the combination of the valve seat and the valve
when reassembling.
Valve Spring - Compress
Valve and Valve Spring - Remove
1.11 Nozzle Gland Stud Bolt and Bridge Guide - Remove
Do not remove the nozzle gland stud bolt and the bridge
guide from the cylinder head, unless they are defective.
If they are removed, see "Nozzle Gland Stud Bolt and
Bridge Guide - Inspect and Replace" of "INSPECTION
AND REPAIR OF BASIC ENGINE."
Nozzle Gland Stud Bolt and Bridge Guide -
Remove
1.12 Fuel Connector - Remove
Do not remove the fuel injection connector, fuel leak-off
connector from the cylinder head unless they are found to be
defective.
Fuel Connector - Remove
Valve spring pusher
P/N : 33591-04500
Stem seal
Valve spring
Valve rotator
Valve cotter
Bridge guide
Nozzle gland
stud bolt
Fuel injection
connector
Fuel leak-off
connector
To Next Page
Loading...
Need help?
General
