Mitsubishi S12A2 User Manual

7-20
Chapter 7 ASSEMBLY OF BASIC ENGINE
4. Rear Mechanism - Assemble
4.1 Rear Plate - Install
(1) Make sure that plugs that block the oil gallery of the
crankcase are installed (3 places).
(2) Apply sealant (ThreeBond 1211) to the packing mount-
ing surface of the crankcase, and install the packing.
(3) Apply the same sealant (ThreeBond 1211) to the pack-
ing, and then install the rear plate.
(4) Tighten the bolts to the specified torque.
(5) Make sure that the bottom face of the rear plate is flush
with the bottom face of the crankcase.Cut off excessive
packing carefully.
Plug - Mounting location
Rear Plate - Install
4.2 Idler Shaft - Install
(1) Tap-in the idler shaft into position using a bolt as guide.
(2) Tighten the bolts to the specified torque.
Idler Shaft - Install
Plug
98 ± 4.9 N·m
{10 ± 0.5 kgf·m}
[72.3 ± 3.6 lbf·ft]
Dowel pin
54 ± 2.7 N·m
{5.5 ± 0.28 kgf·m}
[39.8 ± 1.99 lbf·ft]

Mitsubishi S12A2 Specifications

General

Brand	Mitsubishi
Model	S12A2
Category	Engine
Language	English