Alarm messages
The following table lists possible error messages and a short help to remedy the fault.
Axle suspension
Right axle height sensor is faulty.
The angle sensor that measures the spring deflection for the right wheel is
defective.
The signal voltage is outside of the valid range.
Valid range: 0.5 V to 4.5 V
Drawbar height sensor is faulty.
The angle sensor that measures the spring deflection for the drawbar is defective.
The signal voltage is outside of the valid range.
Valid range: 0.5 V to 4.5 V
Target height of the axle cannot be
maintained.
The planned height of the axle or drawbar cannot be reached within the defined
time.
Mechanical, hydraulic or electrical malfunction.
Contact Customer Service.
Target height of the drawbar cannot be
maintained.
Calibration of the suspension is
required.
Calibrate the suspension.
Suspension: Check parameters.
Values in the configuration outside of the valid range.
AIRTEC
The regulation cannot reach the desired pressure.
Check the air supply to the nozzles and the pressure sensor.
The desired pressure at the nozzle cannot be reached.
The desired pressure at the nozzle cannot be reached.
DISTANCE-Control: Alarm messages during operation
Angle sensor that determines the boom slope is defective.
The signal voltage is outside of the valid range.
Valid range: 0.5 V to 4.5 V
The slope sensor installed on the frame of the field sprayer is defective or was not
To Next Page
Loading...
Need help?
General
