Operating job computer on the field
Tank filling
Filling up the tank manually without additional systems
If you fill up the spray liquid container manually without any additional systems, you need to enter the
new tank content manually on the terminal.
Tank was fully filled up.
Set tank content to 0 liter.
To enter the new tank content when you have completely refilled the spray liquid tank:
1. Switch to the "Tank filling - Manual " screen:
⇨ The following screen appears:
2. - Enter full tank
or
3. In the "New tank content " box, enter the tank content after refilling.
⇨ The new tank content appears in the work screen, in the tank data area.
Filling up the tank with TANK-Control
TANK-Control is a measurement system that constantly measures and displays the tank content.
1. Switch to the "Tank filling - TANK-Control" screen:
2. Start filling.
⇨ While filling is taking place, the filled quantity appears on the "Tank filling - TANK-Control"
screen on the "Current content " line.
3. When the tank is full, switch off pump.
To Next Page
Loading...
Need help?
General
