Configuring the job computer
Selecting and configuring the speed sensor
⇨ The following function icons appear:
- Stop calibration.
- Abort calibration.
4. Drive the previously measured 100m distance and stop at the end.
⇨ During the drive, the currently determined pulses are displayed.
5. - Stop calibration.
6. - Exit the screen.
⇨ The number of pulses appears on the "Wheel pulses" line
Configuring the reverse driving sensor
If the trailed implement or the tractor sends a reverse driving signal through the ISOBUS, the job
computer can use this signal to adjust its regulating behaviour when driving in reverse.
You can find more information in this section: Configuring automatisms when driving in reverse [➙
94]
The following signal sources are possible:
▪ "None" - The job computer should not expect a reverse driving signal. Even if a reverse driving
signal is transmitted through the ISOBUS, the job computer will ignore the signal.
▪ "ISOBUS" - The reverse driving signal is sent by the tractor or a different job computer through
the ISOBUS.
▪ "Sensor" - A reverse driving sensor is connected to the junction box or cable harness of the job
computer.
To select the reverse signal source:
1. Switch to the "SPEED" screen:
>
2. Select the box below the "Reverse drive sensor" parameter.
⇨ The available signal sources appear. See the description at the beginning of this section.
3. Select the signal source.
4. Restart the job computer.
"Simulated speed" function
The simulated speed function is only used during tests and when looking for faults. It simulates the
movement of the implement when the implement is at a standstill.
You can also use this function for technical inspection of field sprayers.
By activating the "Simulated speed" function, it is possible for customer service employees to check
the correct functioning of a sensor.
By default, the value is set at 0 km/h and the function is switched off.
After restarting the computer, the function is always deactivated.
The most recently set value is saved and used for the next activation.
To Next Page
Loading...
Need help?
General
