SECTION 2 -- CONTROLS, INSTRUMENTS AND OPERATION
2--94
The Auto Shift gear span is shown in the
transmission display. Figures 142 and 143 show a 3
gear span of 6, 7 and 8. The currently selected gear
is 7th.
Digital Display: The span of gears will be
represented by flashing bars and the selected gear
by the solid block, see Figure 142.
LED Display: The span of gears will be identified by
flashing digits and the engaged gear by the
permanently lit digit, see Figure 143.
142
With Auto Shift in standby mode, the operator can
manually shift to any gear , even if it is outside the
current range of Auto Shift gears. Providing the
operator selects a gear within the current Auto Shift
range prior to exiting standby mode (i.e. lowering the
3--point hitch), then the Auto Shift function will be
resumed.
However , if the gear selected is outside the current
range when exiting standby, the Auto Shift function
will be cancelled.
If 8th gear is selected and the Auto Shift span is 5,
6 and 7, then the transmission will immediately
downshift to 7th gear on exiting standby mode.
If the Auto Shift span is 6, 7 and 8 and 5th gear is
selected on exiting the standby mode, then the
transmission will remain in 5th until conditions permit
a normal auto upshift to 6th gear. At this point the
original Auto Shift gear span of 6, 7, and 8 will be
re--instated.
143
To Next Page
Loading...
Need help?
General
