SECTION 3 -- FIELD OPERATION
3--108
AUTOMATIC PICK--UP HITCH AND DRAWBAR
The automatic pick--up hitch and drawbar on your
tractor may be the drop down type, swing back type
or the hydraulic extending type.
All pick--up hitches are raised and lowered using the
3--point lift and are fully self-supporting when locked
in the operating (raised) position.
Depending on type, the pick--up hitch will be
equipped with a reversible hook and clevis drawbar
or interchangeable hook and clevis drawbars.
1
184
Raising and Lowering the Hitch (All Types)
With Mechanical Draft Control
Move both position (2) and draft (3) control levers
fully rearwards until the 3-point lift is supporting the
weight of the hitch.
To unlock the hitch, slide the collar (1) upwards
Figure 184, and then pull up and hold the release
handle. Lower the hitch to the ground by means of
the position control lever.
185
With Electronic Draft Control
Rotate the thumb wheel (2) fully forward to position
10. Move the Position Control lever (1) fully
rearwards until the 3-point lift is supporting the weight
of the hitch.
To unlock the hitch, slide the collar (1) upwards
Figure 184, and then pull up and hold the release
handle. Lower the hitch to the ground by means of
the position control lever.
186
To Next Page
Loading...
Need help?
General
