SECTION 7 -- ACCESSORIES
7--6
Additional Services (where fitted)
Your loader may be equipped with additional
functions activated using the buttons (1) on the
joystick knob.
Depending on loader specification, up to three
buttons may be fitted to the joystick. Consult the
loader Operator’s Manual for further information.
8
Attaching the Loader to the Subframe
CAUTION
Before attempting to connect or disconnect the
loader hydraulic services, switch OFF the tractor
engine and relieve any pressure in the hydraulic
hoses by individually selecting both FLOAT
positions. Place the joystick control in Neutral.
Dependent on country, different procedures are used
for removing and attaching the front loader arms.
Consult the installation instructions in your loader
manual.
IMPORTANT: Before connecting the loader
hydraulic hoses, stop the engine and thoroughly
clean the connections to prevent oil contamination.
Loader cylinders are operated by oil drawn from the
tractor hydraulic system, therefore, always check
and replenish the hydraulic system oil after the
loader cylinders have been connected and cycled a
few times. Operating the tractor with a low oil level
may result in damage to the rear axle and
transmission components.
To Next Page
Loading...
Need help?
General
