SECTION 3 -- FIELD OPERATION
3--45
Combined Position and Draft Control
Operation
When starting work, lower the implement to the
required depth by means of the Draft Control lever
(3), as previously described. Observe the implement
as it pulls through the soil.
When the implement stabilises at the required depth,
ease the Position Control lever (2) back until the lift
arms tend to rise. The lift linkage is now operating in
Draft Control but the implement is prevented, by the
Position Control function, from sinking too far when
the draft load reduces.
75
Float Operation
To operate with the lift in float mode move the Draft
and Position Control levers fully forward. This will
enable the lift arms to move up and down freely
allowing the implement to follow the ground
contours.
To Next Page
Loading...
Need help?
General
