SECTION 2 -- CONTROLS, INSTRUMENTS AND OPERATION
2--34
INSTRUMENT CONSOLE
The following text describes the use of the various
switches and controls, etc., mounted on the
instrument console and steering column.
Steering Column Tilt Adjustment
The steering column on your tractor may be tilted and
telescoped. Pull the end of the clamp lever (2) up
(toward you). Move the steering column/wheel to the
most convenient position and return the clamp lever
to the fully down position to lock the steering column
assembly.
Height Adjustment (where fitted)
To alter the steering column height, loosen the centre
boss (1) on the steering wheel by turning
anti--clockwise. Move the steering wheel to the most
covenient position and re--tighten the centre boss.
IMPORTANT: Your tractor is equipped with
hydrostatic power steering. Never hold the steering
wheel at full left or right lock (wheels against the
steering stops) for more than 10 seconds or for more
than a total of 10 seconds in any one minute. Failure
to observe this precaution may result in damage to
steering system components.
62
Key-start Switch
The key-start switch activates the grid heater cold
start device, accessories and the starting motor. See
‘Starting the Engine’ in Section 3.
63
To Next Page
Loading...
Need help?
General
