SECTION 2 -- CONTROLS, INSTRUMENTS AND OPERATION
2--7
CAB (where fitted)
NOTE: The controls on tractors without a cab, from
the instrument console down, are very similar to
those with a cab. Even if your tractor does not have
a cab, you should still read the following text to gain
an understanding of the function and use of the
controls.
Introduction
The cab on your tractor has been designed to provide
operator protection, comfort and convenience.
Inside, the trim panels, roof, and floor are insulated
to reduce noise to a minimum.
T wo wide opening doors permit entry to the cab from
either side, aided by convenient grab handles and
footsteps with anti-slip treads. The doors and rear
window are fitted with gas struts to hold them in the fully
open position. Additionally , the rear window may be
retained in the partially open position for increased
ventilation.
Standard Cab
Standard cab features include a fresh air
heater/defroster, high visibility roof panel, front and rear
wash/wipe, sun visor, tinted glass, interior light and
exterior courtesy lights, cigarette lighter, storage
facilities, interior/exterior rear view mirrors and a choice
of comfortable seats.
Options include air-conditioning, radio, opening front
windscreen and extending exterior rear view mirrors.
3
Low Profile Cab
When fitted with the optional low roof, the overall cab
height is reduced by approximately 2.15 cm. (5.5 in.)
allowing operation in areas of restricted height. The
standard specification with low roof includes fixed
high visibility roof panel, air conditioning and a
pre--wired disposition for the optional
radio/cassette/CD player.
4
To Next Page
Loading...
Need help?
General
