SECTION 3 -- FIELD OPERATION
3--35
If the implement requires additional hydraulic
services, these may be connected to any unused
remote valve. However, for convenience, it is
recommended the second valve (II) is used for this
purpose.
As an alternative, the levers operating remote valves
I and II may be replaced by a joystick located in a
forward position on the right--hand side of the
operators seat.
IMPORTANT: With the joystick operating the rear
remote valves, a float position (F) is available by
moving the lever fully to the right. This function is not
available when operating with a mid--mounted
2--spool remote valve.
52
-- with Electro Hydraulic remote valves:
Electro Hydraulic valves may be used to operate the
front hitch using the remote valve lever or electronic
joystick (where fitted). The Electro Hydraulic levers
function in a similar way to the mechanical levers.
The standard default valve to operate the hitch will
always be valve number IIII. However, it is possible
to set the default to alternative remote valve if
required.
The default valve (IIII) is programmed to operate in
conjunction with the front hitch height limiter. If an
alternative valve is used, the height limiter will not
function until the new valve has been programmed.
To reset the default valve, the tractor must be
stationary with the parking brake applied, ensure all
hydraulic lines are disconnected from the remote
valve couplings.
53
To Next Page
Loading...
Need help?
General
