SECTION 4 -- LUBRICATION AND MAINTENANCE
4--61
Rocker Switch Bulbs
Certain of the rocker switches are internally
illuminated, the bulb being removeable from the rear
of the switch assembly.
The switch assembly is retained by a sprung tag (3)
at either end. Use a small screwdriver to pry one end
of the rocker switch from the sheet metal and
withdraw the switch assembly.
To change a bulb, press in the tag (2) using a small
screwdriver and pull the bulb retainer (1) from the
back of the assembly. The bulbs are of the capless
type, rated at 1.2w and are a push fit in the retainer.
After changing the bulb, push the retainer into the
back of the switch assembly until the tag locates in
the aperture. Re-install the switch assembly.
3
1
2
128
To Next Page
Loading...
Need help?
General
