SECTION 3 -- FIELD OPERATION
3--55
POSITION CONTROL OPERATION
To operate in Position Control, the draft loading
wheel (4) should, ideally, be rotated fully forward to
position 10.
Use the Position Control lever (3) to raise and lower
the 3--point linkage. The implement will raise and
stop at the height set by the height limit control knob.
NOTE: The rate of lift will be adjusted automatically.
If a large movement of the position control lever is
made then the lower links will respond by moving
rapidly. As the links approach the position set by the
Position Control lever, implement movement will be
slower .
97
When the implement is at the required working
height, use thumbwheel (1) to set the adjustable stop
(2) against the Position Control lever (3). Every time
the Position Control lever is moved, it may be quickly
returned to it’s original position, against the stop, to
maintain the required implement height.
If it is required to raise the implement at the headland,
momentarily depress the top of the raise/lower
switch (5), to lift the implement to the position set by
the height limit control knob. When re-entering the
work area, depress the lower part of the switch and
the implement will return to the height originally set
by the Position Control lever (3).
To Next Page
Loading...
Need help?
General
