SECTION 7 -- ACCESSORIES
7--2
COOLANT IMMERSION HEATER
This dealer installed accessory consists of a heating
element fitted into one of the core plug apertures on
the right--hand side of the block. The heater is
available in 115 volts A.C only. This accessory
provides easier starting down to --29° C(--20° F).
WARNING
To avoid shocks or other injuries, never use an
unearthed or inadequate extension lead. Always use
an earthed, three core extension lead, which is rated
for at least a 15 amp load, in conjunction with a
residual current circuit breaker or earth leakage trip
device.
To operate the heater, connect the plug on the free
end of the heater cable (1) to a suitable 115 volt outlet
(or 230 volt using a transformer), for up to four hours
before carrying out the cold weather starting
procedure.
NOTE: The heater may be left plugged in for more
than four hours without harm. However , no
noticeable increase in the heater’s effectiveness will
be achieved after this period.
TRANSMISSION OIL HEATER
This dealer installed accessory consists of a 115
volts A.C. heating element installed in the
transmission housing. A cable connected to the
heater is clipped to the left of P.T.O. shaft housing.
This accessory provides for faster warm up of the
transmission/hydraulic oil when operating in cold
climates.
WARNING
To avoid shocks or other injuries, never use an
unearthed or inadequate extension lead. Always use
an earthed, three core extension lead, which is rated
for at least a 15 amp load, in conjunction with a
residual current circuit breaker or earth leakage trip
device.
To operate the heater, connect the plug on the free
end of the heater cable (1) to a suitable 115 volt outlet
(using a voltage transformer, if necessary) for up to
four hours before starting the engine.
NOTE: The heater may be left plugged in for more
than four hours without harm. However , no
noticeable increase in the heater’s effectiveness will
be achieved after this period.
To Next Page
Loading...
Need help?
General
