SECTION 3 -- FIELD OPERATION
3--96
Adjusting the Stabilisers
In practice, the implement should be attached to the
three--point linkage with the cover (4) on both
stabilisers raised, so as to allow the stabilisers to
telescope freely.
Lift the locking/adjusting lever (2) up over the peg (1)
so that the lever is at right-angles to the stabiliser . T urn
the telescopic section, by means of the lever , so that
the threaded section (3) screws into or out of the
stabiliser . When the length is satisfactory, i.e., the notch
in the cover aligns with the lug on the stabiliser, lower
the lever back down over the peg and close the cover .
The chain should then be adjusted, by placing the
appropriate link over the attaching hook, so that the
cover on the stabiliser is lifted when the implement
is lowered into work.
IMPORTANT: When setting the stabiliser length to
provide sway, ensure that there is no possibility of the
rear tyres fouling the stabilisers or lower links.
164
To Next Page
Loading...
Need help?
General
