SECTION 4 -- LUBRICATION AND MAINTENANCE
4--35
OPERATION 22
CHANGE FUEL PRE--FILTER AND
FUEL FILTER ELEMENTS
FUEL PRE--FILTER
IMPORTANT: Before loosening or disconnecting
any part of the fuel injection system, thoroughly clean
the area to be worked on to prevent contamination.
1. Remove the drain plug (1) at the base of the filter.
2. To allow full rotation of the drain plug ,remove the
sensor wire.
3. Open the drain plug on the sedimenter/filter by
loosening the knob . Allow the fuel to drain out.
Catch the fuel in a suitable container and dispose
of properly.
4. Unscrew and remove the filter from the filter head
and dispose of properly.
5. Install a new filter to the head assembly.
72
6. Before installing the new filter lightly coat the filter
gasket with oil.
7. Rotate the filter until the filter gasket is touching
the filter head. Then give the filter a further
3
/
4
turn to tighten to correct torque (15Nm). Do not
overtighten.
8. Remove and replace the fuel filter in the same
manner .
Procede to bleed the fuel system as follows:
73
To Bleed the Fuel System
1. Press in the retaining clip (1) to release the pipe
from the filter head (4 cylinder engine shown).
74
To Next Page
Loading...
Need help?
General
