24 – ENGLISH
7.4 DELETING A RADIO COMMAND
7.4.1 DELETING A SINGLE COMMAND ASSOCIATED WITH A BUTTON FROM THE RECEIVER’S MEMORY
During the execution of the procedure indicated in “Table 16” it is possible to delete the memorisation of a command associated with a button
a
Warning! If the transmitter is memorised in “Mode 1” (refer to the “Memorisation in “Mode 1”” paragraph), during the pro-
cedure the entire transmitter is deleted, in other words, all buttons of the radio remote control.
Table 16
DELETING A SINGLE BUTTON FROM THE RECEIVER’S MEMORY
Description Symbols used
Press and hold the “Radio” button on the control unit and wait for LED “R” to light
up green and switch off. Release the “Radio” button
On the transmitter to be deleted
If one-way, press and hold button (*4) to be deleted and release it only once LED
“R” on the control unit has emitted the 1st of 5 fast green ashes (=memorisation
completed correctly).
If two-way, press and release the button to be deleted (*4); LED “R” on the control
unit will emit 5 fast green ashes (=deletion completed successfully).
(*4) - If the transmitter is memorised in “Mode 1” (see “Memorisation in “Mode 1””), any button can be pressed. If the transmitter is memorised in
“Mode 2” (see “Memorisation in “Mode 2””), the entire procedure must be repeated for each memorised button that must be deleted.
7.4.2 DELETING THE RECEIVER'S MEMORY (FULLY OR PARTIALLY)
In a one-way system, the code deletion procedures involve the receiver alone. In a two-way system, it will instead be necessary to delete the pairing
also on the radio remote control.
To perform this procedure, consult the instruction manual of the relevant transmitter.
Table 17
FULL OR PARTIAL DELETION OF THE RECEIVER’S MEMORY.
Description Symbols used
Press and hold the “Radio” button on the control unit and wait for LED “R” to light
up green and switch off. It will start ashing after a few seconds.
---
Deletion modes
To delete the receiver’s memory, release the “Radio” button precisely at the 5th
ash.
To Next Page
Loading...
Need help?
General
