Nice SPIDER Series User Manual

ENGLISH – 25
7.4.3 LOCKING (OR RELEASE) OF MEMORISATIONS CARRIED OUT WITH THE “NEAR THE CONTROL UNIT” PROCEDURE
AND/OR THROUGH THE “ENABLING CODE”
Through the procedure indicated in “Table 18”, it is possible to inhibit the memorisation of new transmitters in the receiver when attempting to use the
“near the receiver” procedure (see “Memorising a new transmitter “near the receiver”.”) or the “enabling code” procedure (see “Memorising a
new transmitter using the “enabling code” of an old transmitter already memorised in the receiver”)
The default setting is “ON” for both procedures. To perform the following procedure it is necessary to have a transmitter already memorised in the re
-
ceiver.
Table 18
LOCKING (OR RELEASE) OF MEMORISATIONS CARRIED OUT WITH THE “NEAR THE CONTROL UNIT” PROCEDURE AND/OR THROUGH THE “ENABLING
CODE”
Description Symbols used
Disconnect the power supply by removing fuse F2 and the battery pack (if present). Wait 10
seconds.
OFF 10 s
Press and hold the “Radio” button and simultaneously restore the power supply.
ON
+
LED “R” will rst emit signals relative to the memorised transmitters followed by short
orange ashes.
---
---
Release the “Radio” button precisely at the end of the second orange ash.
Within 5 seconds repeatedly press and release the “Radio” button to choose one of the following
functions, identiable by the status of LED “R”:
< 5 sec >
No lock active = LED OFF
---
---
Locking of the memorisation “near the control unit” = RED LED
Locking of the memorisation with the “enabling code” = GREEN LED
Locking of both memorisations (“near the control unit” and with “enabling code”) = ORANGE
LED
Within 5 seconds on a transmitter already memorised in the receiver, press and release a
button (memorised) to save the function that has just been chosen

Nice SPIDER Series Specifications

General

Brand	Nice
Model	SPIDER Series
Category	Door Opening System
Language	English