44 – ENGLISH
PARAMETERS AND PROGRAMMABLE FUNCTIONS
11
11 PARAMETERS AND PROGRAMMABLE FUNCTIONS
The following pages list all the parameters and functions of the control unit with their relative reference values. With the exception of a few parameters
that are read-only, almost all the available parameters can be modied through all the compatible Nice interfaces.
a
WARNING: Nice reserves the right to modify the reference values and the functions without prior notice.
11.1 KEY TO THE SYMBOLS
This key shows and describes all the symbols used in the following pages.
Z
= Automatic procedure
A
= Manual procedure
c
= Multi-board parameter
e
= Light door setting
k
= Heavy door setting
d
= Read-only parameter (non-modiable parameter)
11.2 COMMON PARAMETERS
Name
This parameter enables the user to assign the automation with a name other than the original, to facilitate identication (e.g. “northern gate”). It is pos-
sible to choose a name comprising maximum 24 characters, including spaces.
Series (0 4 63, default = 0)
The series is a number that has to be assigned to each gearmotor, receiver or other device potentially connectable on a BusT4 network, to dene its
“classication area”. Subsequently, when using automations in a complex system, all devices with the same series number can be controlled simulta
-
neously.
Address (1 4 127, default = 3)
The address is a number that has to be assigned to each gearmotor, receiver or other device potentially connectable on a BusT4 network, to distinguish
it from other devices in a series. Therefore all devices within a series must have a different address from one another.
Group (0 4 15, default = 0)
The function enables the user to assign a number to a device to be controlled (for example a gearmotor or other device potentially connectable to a
BusT4 network), which enables this device to belong to a specic “command group”.
Multiple devices, even belonging to different series, can be part of the same group. Up to 14 groups of devices can be created and, in particular, the
same device may be inserted in 4 different groups.
– simultaneous control of different devices inserted in a group, even if some of these belong to different series:
– use of a single receiver, installed in one of the devices belonging to the group, to control all the devices belonging to this group.
Firmware version d
This function can be used to view the rmware version present in a device.
Hardware version d
This function can be used to view the hardware version present in a device.
Serial number d
This function can be used to view the serial number identifying a specic device. This number is different for each device, even if of the same model.
To Next Page
Loading...
Need help?
General
