Omron NT31 Setup Manual

166
Setting Conditions for Communications with Host by Using Memory Switches Section 6-7
6-7-5 Setting the Memory Link Method
Set the communications conditions for the host link method at serial port A or
serial port B by following the operation from the System Menu shown below.
Check the communications settings of the host to be used.
Select Maintenance Mode.
Select Memory Switch.
In this example, serial port A is used.
Ver 4.12
Display the fourth memory switch screen by
pressing the [↓] (next screen) or [↑]
(previous screen) touch switch.
Press the touch switch corresponding to the
port at which the memory link method is to
be set (Comm. A Method or Comm. B
Method) to display the setting option
Memory Link.
The setting option changes each time the
touch switch is pressed.In this example,
serial port A is used.
Press the Set touch switch to the right of the
port at which the setting has been made.

Omron NT31 Specifications

General

Brand	Omron
Model	NT31
Category	Touch terminals
Language	English