178
System Settings Section 6-9
6-9-8 Setting the Screen Saver Start-up Time
The NT31/NT31C has a function to maximize the service life of the backlight
and prevent the formation of an afterimage by turning off the screen display
and the backlight if no operation is performed for a certain period of time.
The Screen Saver Start up Time setting determines the time interval before
the screen saver function operates.
The setting range is 0 to 255 minutes. The default (factory) setting is 10 min-
utes. If 000 is set, the screen saver function does not operate.
The screen saver can be canceled, and previous screen redisplayed, by any
of the following operations.
• Touching any part of the touch panel
• Screen switching due to PT status control area operations
• Screen switching due to bit memory table operations
• Execution of any of the following PT status control bit operations:
• Changing the backlight mode
• Screen printing (change from OFF to ON)
• Screen display (change from OFF to ON)
Reference: • It is possible to display the character string stored in character string
memory table No. 0 at random positions and in random colors while the
screen display is off. For details, refer to 6-9-7 Setting Screen Saver
Movement (page 176). Note however that, when this feature is used, the
backlight does not go off.
• For details on the screen saver function, refer to 2-15-4 Screen Saver
Function in the Reference Manual.
• Screen saver function is enabled only through RUN mode of NT31/
NT31C. In System Menu or System Installer mode, this function is not
started.
To Next Page
Loading...
Need help?
General
