172
System Settings Section 6-9
The default (factory) setting is ON.
Set the key press sound by following the menu operation from the System
Menu shown below.
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
• To confirm the settings and quit the memory switch setting screen, press
the Quit touch switch. The settings made last will be set and the NT31/
NT31C will return to the MAINTENANCE MODE MENU screen.
• To quit the memory switch setting screen without confirming the settings,
press the Abort touch switch. The NT31/NT31C will return to the MAIN-
TENANCE MODE MENU screen with the previous settings still in effect.
6-9-4 Setting the Buzzer Sound
The NT31/NT31C has a function for sounding a buzzer in response to an
instruction from the host, or when an error occurs. It is possible to set whether
or not the buzzer actually sounds with the memory switches.
•ON:
The buzzer sounds in response to instructions and when an error occurs.
•OFF:
The buzzer does not sound in response to instructions or when errors
occur.
• ERROR ON:
The buzzer sounds only when an error occurs.
Select Maintenance Mode.
Select Memory Switch.
Ver 4.12
Press Key Press Sound to display ON
or OFF.
The setting option changes each time
the touch switch is pressed.
To Next Page
Loading...
Need help?
General
