173
System Settings Section 6-9
The default (factory) setting is OFF.
Reference: • There are other instructions and settings relating to the buzzer, but this
memory switch setting has the highest priority.
• For details on the buzzer, refer to 2-15-5 Buzzer Function in the Refer-
ence Manual.
Set the buzzer sound by following the menu operation from the System Menu
shown below.
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
• To confirm the settings and quit the memory switch setting screen, press
the Quit touch switch. The settings made last will be set and the NT31/
NT31C will return to the MAINTENANCE MODE MENU screen.
• To quit the memory switch setting screen without confirming the settings,
press the Abort touch switch. The NT31/NT31C will return to the MAIN-
TENANCE MODE MENU screen with the previous settings still in effect.
6-9-5 Setting the Printer Controller
The NT31/NT31C has a function for printing out data at a printer connected to
it in response to an instruction from the host or operation at the NT31/NT31C.
Three types of printer can be connected to the NT31/NT31C: select the type
used with this memory switch setting.
•ESC/P:
Select Maintenance Mode.
Select Memory Switch.
Ver 4.12
Press Buzzer Sound to display ON, OFF,
or ERROR ON.
The setting option changes each time
the touch switch is pressed.
To Next Page
Loading...
Need help?
General
