Pyronix 256 User Manual

PCX SMS AND PCX 256 SYSTEM MANUAL
Page: 114 RINS871-3
16.4 Addressing the Radio Expander
Once a radio expander is installed on the system in must be enabled at both the radio expander and the
PCX system. To perform this at the system you will need to go to ‘Install RIX’ – see page: 48. To enable this
at the radio expander, follow the instructions below:
¾ Hold down the ‘ENTER’ button until the mode and address are
displayed.
“E0” = means End of Line mode, Address 0.
“I0” = means ID mode, Address 0.
¾ Press the ’MO’ button on the detector to toggle between End of
Line and ID modes.
ENTER
0E
¾ Press the ‘AZ’ button to select the Wireless Input Expander
address number.
¾ Press the ‘ENTER’ to confirm your selection.
A
Z
1E
16.5 Assigning Radio Detectors
¾ Press the ‘AZ’ and scroll to the input number you wish to assign a
wireless detector to:
A
Z
10
¾ Press the ‘’RESET’ button on the detector you wish to assign to
that particular zone.
Ensure that the jumper on the detector PCB is placed in the “EU”
position.
When the detector is assigned, the two dots on the display with
flash.
10
16.6 Deleting Radio Detectors
¾ Press the ‘AZ’ and scroll to the input number you wish to delete.
A
Z
10
¾ Press the ‘’CLEAR’ button. The dots should have cleared,
indicating the detector has been deleted.
CLEAR
10
16.7 Display the Signal Strength
The radio expander can monitor the signal of the detectors connected onto the system:
¾ Press the ‘AZ’ and scroll to the input number you wish to check.
The display will show the input number and two dots.
A
Z
10

Pyronix 256 Specifications

General

Brand	Pyronix
Model	256
Category	Security System
Language	English