Chapter 2: Using the display 17
Data
3d chart
Requires upgraded cartography (chart card).
2.4 First time use
When you first use your A-Series Display after it has been installed
we recommend that you carry out the following:
Turn on the display
To Power ON:
Press and hold the POWER key until the screen shows
the Raymarine logo.
Select a page set.
When you first turn the display on you will be prompted to select a
page set from those available.
Note: You can change the required page set at any time. See
Displaying applications on page 25.
To Select a page set at first time Power on:
1. Use the trackpad Up/Down keys to select the required Page Set.
2. Press OK when complete.
•
View data generated by the system or by
instruments available on NMEA 0183,
NMEA 2000 or SeaTalk
ng
.
D9520-1
•
Display a 3D view of land, sea & features.
•
Locate where you are.
•
Interpret your surroundings.
•
Monitor where you are going.
•
Go to an existing waypoint.
•
Navigate a route.
•
Synchronize with the 2D chart.
•
Identify fishing spots.
Highlight appropriate
pre-configured page set
81314-1_A Series Reference Guide.book Page 17 Thursday, August 28, 2008 9:23 AM
To Next Page
Loading...
Need help?
General