Raymarine A Series A50 User Manual

Chapter 3: Waypoints 31
3D chart and CDI waypoints
On a 3D chart or Course Deviation Indicator (CDI) only the active
waypoint is shown.
3.2 Using Waypoints
This section details the creation, navigation and editing of
waypoints.
The waypoint toolbar
You can use the waypoint toolbar to create, edit and navigate to
waypoints.
To display the waypoints toolbar
1. Press the WPTS/MOB button:
Creating waypoints
You can place a waypoint at:
• the cursor.
• your boat’s position.
• a point specified by latitude and longitude or Loran TD co-
ordinates.
To set up your system for Loran TD coordinates refer to System
Setup menu on page 129.
To place a waypoint at the cursor
1. Press the WPTS/MOB button to display the waypoints toolbar.
Active waypoint
WAYPOINT AT
CURSOR
WAYPOINT AT
VESSEL
WAYPOINT AT
LAT/LONG...
GO TO WAYPOINT
OPTIONS…
REVIEW AND EDIT
WAYPOINTS
81314-1_A Series Reference Guide.book Page 31 Thursday, August 28, 2008 9:23 AM

Raymarine A Series A50 Specifications

General

Brand	Raymarine
Model	A Series A50
Category	Monitor
Language	English