Renesas PG-FP5 User Manual

PG-FP5 CHAPTER 8 USAGE COMMUNICATION COMMANDS
R20UT0008EJ0400 Rev. 4.00 Page 141 of 240
Jul 15, 2010
Table 8-2. List of FP5 Device Commands
Command name Description
bln Executes the [Blank check] command.
con Executes the processes from “transition to flash memory programming mode” to “signature verification”.
dcon Executes the termination of the flash memory programming mode.
ep or epv Executes the [Autoprocedure (E.P.)] command.
ers Executes the [Erase] command.
gid Obtains the on-chip debug security ID get for the target device.
gob Obtains the information of option byte get for the target device.
gos Obtains the information of flash option get for the target device.
gsc Obtains the information of security get for the target device.
idc Executes the [Set OCD Security ID] command.
opb Executes the [Set Option bytes] command.
prg Executes the [Program] command.
read Executes the [Read] command.
scf Executes the [Security] command.
sig Executes the [Signature read] command.
sum Executes the programming GUI [Device] menu -> [Checksum] command.
vrf Executes the [Verify] command.

Renesas PG-FP5 Specifications

General

Brand	Renesas
Model	PG-FP5
Category	Motherboard
Language	English