Renesas PG-FP5 User Manual

PG-FP5 CHAPTER 8 USAGE COMMUNICATION COMMANDS
R20UT0008EJ0400 Rev. 4.00 Page 140 of 240
Jul 15, 2010
8.2 Command List
The following is a list of FP5 control commands and device commands.
Table 8-1. List of FP5 Control Commands
Command name Description
autocon Selects and confirms automatic or manual execution of the processes, from “transition to flash memory
programming mode” to “signature verification”, and “the termination of the flash memory programming
mode”.
brt Confirms and changes the data transfer rate during serial communication with the host machine.
conf Displays a list of the information stored in the FP5 and changes the number of programming area
sections.
dwnprm Downloads the PR5 file.
downset Downloads the ESF file.
fcks Executes the programming GUI [File] menu -> [Checksum...] command.
files Displays the information concerning the program file that was downloaded to the FP5.
fpga_up Updates the FPGA.
hex Uploads the program file in Intel HEX format.
hlp Displays a list of available commands, with simple descriptions.
lod Downloads the program file.
prm Displays the information concerning the PR5 file and ESF file that were downloaded to the FP5.
progarea Confirms, changes and deletes data in the valid programming areas.
pwr_off Turns off the FP5 power supply.
res Resets the FP5.
security Confirms the security state that can be set by the [FP5 Manager] command.
selftest Executes a self-test.
sound Sets the buzzer.
srec Uploads the program file in Motorola HEX format.
trc Displays the communication information between the FP5 and target device.
upprm Uploads the PR5 file.
upset Uploads the ESF file.
ver Displays the FP5 version and FP5 mode.
version_up Updates the firmware.

Renesas PG-FP5 Specifications

General

Brand	Renesas
Model	PG-FP5
Category	Motherboard
Language	English