PG-FP5 CHAPTER 8 USAGE COMMUNICATION COMMANDS
R20UT0008EJ0400 Rev. 4.00 Page 152 of 240
Jul 15, 2010
8.4.8 fpga_up command
Updates the FPGA.
Input format
'fpga_up'
Description of the function
Updates the FPGA version. After this command is executed, the FPGA file must be downloaded to the FP5 in ASCII
format using communications software. If using HyperTerminal, select Transfer(T) -> Transfer text file(T)..., and then
select the FPGA file. After the FPGA version has been updated, the FP5 power supply will be automatically turned off.
Example of usage
Command Status Status LED Message display Screen output
Display after executing the
command (before downloading)
Press y to continue.
Press n to cancel.
Off *** BUSY ***
Are you sure, you want to
update the FPGA (y/n)?
Display after pressing y Off *** BUSY *** Preparing storage ...OK
Now loading...
Display during download Off *** BUSY *** ...
Display after end of normal
download
Press y to continue.
Press n to cancel.
Off *** BUSY *** Refer to <1> below.
fpga_up
Display after pressing y Off
Programming
FPGA
Refer to <2> below.
<1>
OK
**** CAUTION ****
Now the FPGA will be written.
Please ensure that:
- the correct FPGA Update file has been downloaded
- the Power is NOT disconnected during this operation
- the Programmer is NOT reset during this operation
Do you want to continue (y/n)?
<2>
Starting FPGA programming...
100% done
FPGA Update succeeded.
PG-FP5 Power will be switched OFF now....
To Next Page
Loading...
Need help?
General
