PG-FP5 APPENDIX A MESSAGES
R20UT0008EJ0400 Rev. 4.00 Page 209 of 240
Jul 15, 2010
A.3 Information Dialog Boxes for Programming GUI Operation
(1/3)
No. Message Description
I 2100 Please setup host connection again. After FP5 reset, communication with FP5 was attempted
but failed. Try [Programmer] - [Setup host connection] in
the menu.
I 2200 Please open 'Setup' form menu. It will help you down load
parameter & setting files
Open [Setup] in the menu and then download the PR5 or
ESF file.
I 2201 Parameter/setting files are not matched. Information does not match the one defined in the PR5/ESF
file.
The cause may be the following:
1. The PR5 or ESF file, which is defined in the INI file, is
different from the one stored in the FP5.
2. Information on the PR5 or ESF file is missing in the INI
file, but a valid PR5 or ESF file is stored in the FP5.
3. No PR5 or ESF file is stored in the FP5, but valid PR5 or
ESF file has been detected because they are defined in
the INI file.
I 2202 Parameter/setting files are not find. The PR5 or ESF file is missing.
No valid PR5 or ESF file is defined in the INI file.
Store a valid PR5 or ESF file in installation-folder\FP5_PRJ.
I 2203 Are you sure, you want to update the Firmware?
Select whether to update the firmware.
Click 'Ok' to update the firmware. Click Cancel to cancel the
operation.
I 2204 Are you sure, you want to update the FPGA?
Select whether to update the FPGA.
Click 'Ok' to update the FPGA. Click Cancel to cancel the
operation.
I 2207 Do you really want change parameter area format? All data
will lost after this action
Select whether to change the factor for dividing the
programming area. After this operation, all data will be lost.
I 2208 Information defined in initial file is not enough or it is not
matched with FlashProgrammer. Setup parameters is
needed.
The settings in the ESF file are insufficient or do not match
the settings made in the FP5. Device setup is required.
I 2209 Information defined in initial file is not complete matched
with FlashProgrammer. Do you want to go Setup dialog?
The contents of the ESF file do not match those stored in
the FP5. Select whether to open the Device Setup dialog
box.
I 2210 Updating the firmware will take several minutes.
ATTENTION:
-The process of updating your firmware must NOT be
interrupted! --Without firmware this FP5 GUI will NOT run
properly.
Install new firmware in your programmer?
The firmware update will take several minutes.
ATTENTION:
Firmware update cannot be aborted. The FP5 may not
operate normally if proper firmware is not installed.
Select whether to update the firmware.
To Next Page
Loading...
Need help?
General
