PG-FP5 CHAPTER 1 OVERVIEW
R20UT0008EJ0400 Rev. 4.00 Page 18 of 240
Jul 15, 2010
Table 1-1. Hardware Specifications (2/2)
Hardware Items Specifications
CPU clock supply 1 MHz, 2 MHz, 4 MHz, 5 MHz, 6 MHz, 8 MHz, 9 MHz, 10 MHz, 12 MHz, 16 MHz, 20 MHz
Tar get
interface
Note 1
GND cable Approximately 1 m
Remote
interface
Remote connector 15-pin D-SUB female connector
Notes 1. The maximum communication speed in the interface may vary depending on the device and environment
used.
2. V
DD for the target system is supplied for the purpose of supplying power to the target device through which
writing is performed, so the specification cannot secure sufficient capacity to operate the target system. Use
the power source on the target system when performing on-board programming.
3. The AC adapter differs depending on the region where the product is being used. For details, see Table 1-2
AC Adapters for PG-FP5 Used in Each Region. An AC adapter is required when using the PG-FP5, so be
sure to purchase an AC adapter.
1.7 AC Adapters for PG-FP5
The specifications of the AC adapter for the PG-FP5 differ depending on the region where the product is being used.
Be sure to use the appropriate AC adapter for your region. Note that an AC adapter is not included with the PG-FP5. The
appropriate AC adapter must be purchased separately.
Table 1-2. AC Adapters for PG-FP5 Used in Each Region
Name Region
Notes 1, 2
Part Number
Note 3
Japan QB-COMMON-PW-JP
USA QB-COMMON-PW-EA
China QB-COMMON-PW-CN
Hong Kong QB-COMMON-PW-HK
Korea QB-COMMON-PW-KR
Singapore QB-COMMON-PW-SG
AC adapter
(sold separately)
Chinese Taipei QB-COMMON-PW-TW
Notes 1. The AC adapter corresponding to the region from which the order was received will be shipped.
2. For regions other than those listed above, please contact a Renesas Electronics sales representative or
distributor.
3. You can only order the AC adapter that can be used in your region.
To Next Page
Loading...
Need help?
General
