PG-FP5 CHAPTER 8 USAGE COMMUNICATION COMMANDS
R20UT0008EJ0400 Rev. 4.00 Page 165 of 240
Jul 15, 2010
8.4.22 upset command
Uploads the ESF file.
Input format
'upset'
Description of the function
If the ESF file has been downloaded to a valid programming area, then executing this command will upload the ESF file.
Example of usage
Command Screen output
upset Press 'return' to start/continue output.
After the command is executed, pressing the Return key will start the upload. See below.
[FlashproCustomerSettingFile]
:
[CHECKSUM]
SUM=F7D4A9E7
[EOF]
8.4.23 ver command
Displays the FP5 version.
Input format
'ver'
Description of the function
Displays the FP5 version (firmware version, board hardware version, FPGA version, and serial number).
Example of usage
Command Screen output
ver Firmware Version Vx.xx
Board H/W Vx, FPGA Vx
Serial No.:xxxxxxxxxx
Standard mode unsecured
To Next Page
Loading...
Need help?
General
