Renesas PG-FP5 User Manual

PG-FP5 CHAPTER 8 USAGE COMMUNICATION COMMANDS
R20UT0008EJ0400 Rev. 4.00 Page 169 of 240
Jul 15, 2010
8.5.2 con command
Executes the processes from “transition to the flash memory programming mode” to “signature verification”.
Input format
'con'
Description of the function
Executes the processes from “transition to the flash memory programming mode” to “signature verification”. In order to
use this command, “manual” (off) must be set with the autocon command beforehand.
Example of usage
Command Status Status LED Message display Screen output
Display while executing the command BUSY Connecting:
Display after executing the command
[When completed normally]
PASS
Returns to the display before
executing the command.
PASS
Dxxxxxxx>
con
Display after executing the command
[When terminated abnormally]
ERROR
ERROR: xxx
xxxxxxxxxxxxxxxx
ERROR(Exxx): <text>
8.5.3 dcon command
Executes the process to end the flash memory programming mode.
Input format
'dcon'
Description of the function
Executes the process to end the flash memory programming mode. In order to use this command, "manual" (off) must
be set with the autocon command beforehand.
Example of usage
Command Status Status LED Message display Screen output
Display while executing the command BUSY Disconnecting: con
Display after executing the command PASS
Returns to the display before
executing the command.
Device disconnected.

Renesas PG-FP5 Specifications

General

Brand	Renesas
Model	PG-FP5
Category	Motherboard
Language	English