Renesas PG-FP5 User Manual

PG-FP5 APPENDIX A MESSAGES
R20UT0008EJ0400 Rev. 4.00 Page 205 of 240
Jul 15, 2010
A.2 Error/Warning Dialog Boxes for Programming GUI Operation
(1/4)
No. Message Description
E 1100 Communication within host PC and FlashProgrammer is
broken
An error occurred in communication between the host
machine and the FP5. Check the cable connection and FP5
power supply.
E 1101 Can't setup communication within host PC and
FlashProgrammer
Communication between the host machine and FP5 cannot
be established. Check the cable connection and power
supply. Moreover, check if the USB driver is installed
correctly.
E 1102 Can't find parameter file The specified PR5 file could not be found.
E 1103 Open parameter file failed The specified PR5 file cannot be opened.
E 1105 Unable to open last active PRM/SET file. Using most recent
settings.
The PR5/ESF file in the valid programming area cannot be
opened. The latest setting will be used.
E 1106 Firmware is not valid or version is lower than requirement. Incorrect version information or an old version was
detected. Update the FP5 firmware.
E 1107 Parameter area format is not match with initial file. Do you
want reset parameter area format?
The factor for dividing the programming area does not
match the one defined in the INI file. Select whether to
reset the division factor. If reset, it is divided into four areas
and the contents are deleted.
E 1108 No invalid Parameter file defined. GUI can not work
properly.
The GUI will not operate normally because no valid PR5 file
has been defined. Set it in the Device Setup dialog box.
E 1109 No parameter file exists in this project folder. Please select
parameter files.
There is no parameter file in user selected folder. GUI
waited user to find out one or more parameter files in other
folder.
E 1201 Invalid file. The specified file cannot be opened. Set it in the Device
Setup dialog box.
E 1202 <Setting file name> is not valid. Using most recent settings. An incorrect format or value was detected in the ESF file.
The ESF file defined in the INI file will be used instead. Set
it in the Device Setup dialog box.
E 1203 <Parameter file name> is not valid. Using most recent
settings.
An incorrect format or value was detected in the PR5 file.
The ESF file defined in the INI file will be used instead. Set
it in the Device Setup dialog box.
E 1204 Download of parameter file failed. Downloading of the PR5 file has failed. The PR5 file may
be invalid. Re-set the connection between the host machine
and FP5.
E 1205 Download of setting file failed. Downloading of the ESF file has failed. The ESF file may
be invalid. Re-set the connection between the host machine
and FP5.

Renesas PG-FP5 Specifications

General

Brand	Renesas
Model	PG-FP5
Category	Motherboard
Language	English