PG-FP5 APPENDIX A MESSAGES
R20UT0008EJ0400 Rev. 4.00 Page 206 of 240
Jul 15, 2010
(2/4)
No. Message Description
E 1206 File name is not valid. The specified file cannot be opened for writing. Make sure
that the file attribute is not set to read-only.
E 1400 Password is invalid.
Effective password consists one to eight any alphanumeric
character.
It is case insensitive.
Password contains invalid character or out of size range.
E 1401 The password does not match.
[Yes]: Retry to input the password
[No]: Initialize the password and format to the shipment
condition.
Password is different with defined content.
E 1501 This file is not valid. The file opened with the HEX Editor is invalid.
E 1502 Caution: Data Flash access unit is DWORD. The data flash area can be accessed in double-word units,
but an access was attempted in unsupported units.
E 1503 Caution: Out of range! The address range for saving data is out of the code flash
or data flash address range. Check the start/end address.
E 1504 Caution: Start address should not larger than End address. The start address is larger than the end address. Check the
start/end address.
E 1505 Caution: End address should not smaller than start
address.
The end address is smaller than the start address. Check
the start/end address.
E 1506 The file cannot be read. The file opened with the HEX Editor is invalid.
E 1507 No HEX data. The program file format may be incorrect.
E 1508 The file cannot be written. Saving of the program file has failed. Check if this file is
occupied by another program.
E 1509 Temporary file could not be created.Abort The temporary file cannot be created. Creation was
aborted. Confirm that sufficient memory capacity is
available in Windows.
E 1510 Can not open <file name> Abort <file-name> cannot be opened.
E 1511 File load error. Abort An error occurred during file reading or writing.
E 1512 Memory cannot be allocated. Confirm that sufficient memory capacity is available in
Windows.
E 1513 Memory reallocation error Confirm that sufficient memory capacity is available in
Windows.
E 1514 Check sum error. Continue? It was detected that the checksum of the program file
opened by the HEX editor was invalid. Click OK to continue
checksum verification. Click Cancel to abort checksum
verification.
E 1515 Cannot open <file name> Abort. The program file specified by the HEX editor cannot be
opened.