User Tools (System Settings)
74
5
Accessing User Tools (System Settings)
This section is for key operators in
charge of this machine. You can
change or set the machine's default
settings.
Note
❒ Operations for system settings are
different from normal operations.
After using User Tools, be sure to
exit. ⇒ p.74 “Exiting from User
Tools”
❒ Any changes you make with User
Tools remain in effect even if the
main power switch or operation
switch is turned off, or the {
{{
{Energy
Saver}
}}
} or {
{{
{Clear Modes}
}}
} key is
pressed.
Changing Settings
Note
❒ If a key operator code has been set,
the key operator code entry dialog
box appears. Enter the code, and
then press the [OK] key. ⇒ p.90
“Key Operator Code”
A
AA
A
Press the {
{{
{User Tools/Counter}
}}
} key.
B
BB
B
Press the [System Settings] key.
C
CC
C
Select the desired menu, and then
press the desired key.
D
DD
D
Change settings by following in-
structions on the display panel,
and then press the [OK] key.
Note
❒ To cancel changes made to set-
tings and return to the normal
function display, press the {
{{
{User
Tools/Counter}
}}
} key.
Exiting from User Tools
A
AA
A
Press the {
{{
{User Tools/Counter}
}}
} key.
Changing system settings is fin-
ished, and the machine returns to
Copy or Print mode.
Note
❒ You can also exit from User
Tools by pressing the [Exit] key.
MartiniC1_GBzen2_FM.book Page 74 Friday, April 19, 2002 2:18 PM
To Next Page
Need help?
General
