Windows XP Configuration
40
3
Installing SmartNetMonitor for Client
Install SmartNetMonitor for Client from the CD-ROM labeled “Printer Drivers
and Utilities”. For more information about how to install, see the Printer Refer-
ence 1.
After the installation is complete, configure the printer port with SmartNetMon-
itor for Client. See p.41 “Setting Up the Printer Driver”.
Deleting the port
The following procedure allows you to delete the printer port. If you want to de-
lete the port which is currently used in Windows, switch the port to another such
as “FILE”, and then delete it. For more information about SmartNetMonitor for
Client, see SmartNetMonitor for Client Help.
A
AA
A
From the [Printers and Faxes] window, click the icon of the printer which uses
SmartNetMonitor for Client to print. On the [File] menu, click [Properties].
B
BB
B
Click the [Ports] tab, and then make sure that the SmartNetMonitor for Cli-
ent port is shown in the [Print to the following port(s)] box.
Remember the port name because this port should be deleted later.
C
CC
C
Select the [FILE] check box in the [Port] column.
D
DD
D
Click [OK] to close the Printer Properties.
The port which is currently in use is changed.
E
EE
E
Open the Printer Properties of the same printer.
F
FF
F
Select the [Ports] tab.
G
GG
G
At the [Port] column in the [Print to the following port(s)] box, click the Smart-
NetMonitor for Client port name as in step
B
BB
B
.
H
HH
H
Click [Delete Port].
I
II
I
After the confirmation message appears, click [Yes].
The port is deleted.
J
JJ
J
Click [Close] to close the Printer Properties.
To Next Page
Loading...
Need help?
General
