Using the Control Panel
52
5
Host Interface
Edge to Edge Print You can select whether or not to leave margins on the paper.
• On
• Off
Note
❒ Default: Off
Quantity of Print Sets You can set the number of print sets when you use the PCL or
RPCS™ printer driver.
• 1 to 999 by 1
Note
❒ Default: 1
Menu Description
I/O Buffer You can set the size of the I/O Buffer. Normally it is not necessary
to change this setting.
• 128 KB
• 256 KB
• 1 MB
Note
❒ Default: 128 KB
I/O Timeout You can set how many seconds the machine should wait before
ending a print job. If data from another port often arrives in the
middle of the print job, you should increase the timeout value.
• 10 seconds
• 15 seconds
• 20 seconds
• 25 seconds
• 60 seconds
Note
❒ Default: 15 seconds
Menu Description
To Next Page
Loading...
Need help?
General
