Setting Paper on the Bypass Tray
15
1
A
AA
A
Open the bypass tray.
B
BB
B
Adjust the paper guides to the paper size.
Important
❒ If the paper guides are not flush against the paper, skewed images or paper
misfeeds might occur.
C
CC
C
Gently insert the paper face up in the bypass tray until the beeper sounds.
1. Extender
2. Paper guides
Note
❒ Be sure to set paper in L orientation as shown in the illustration above.
❒ The beeper will not sound if it is turned off. Gently insert the paper until it
stops.
❒ Do not stack paper over the limit mark, otherwise a skewed image or paper
misfeeds might occur.
❒
Open out the extender to support paper sizes larger than A4
L
, 8
1
/
2
"×11"
L
.
❒ Fan the paper to get air between the sheets to avoid a multi-sheet feed.
❒ When setting an OHP transparency, make sure that its front and back sides
are properly positioned.
❒ Select the paper type when printing on OHP transparencies or thick paper
(over 105g/m
2
). For details, see p.18 “Setting thick paper or OHP transpar-
encies”.
ZGUH030E
ZGWH071E
2
1
To Next Page
Loading...
Need help?
General
