OHP transparencies
Printer setup
Select [Paper Input] [Paper Type: Bypass Tray]
[OHP (Transparency)].
Printer driver setup Select [OHP Transparency] in [Paper type].
Supported paper feeding tray Bypass tray
Paper capacity
Make sure paper is not stacked higher than the
paper guides inside the bypass tray.
Duplex printing Not supported
Additional cautions
• When loading OHP transparencies, take care
not to load them upside down. Doing so may
cause a malfunction.
• It is recommended to place one sheet at a
time.
• Make sure to fan OHP transparencies every
time before printing. Leaving OHP
transparencies loaded in the paper tray may
cause them to stick together and result in a
misfeed.
• If multiple OHP transparencies are fed at the
same time, load them one by one.
• When printing on OHP transparencies,
remove the transparencies one by one as they
are output.
Letterhead
Printer setup
Select [Paper Input] [Paper Type: (tray name)]
[Letterhead].
Printer driver setup Select [Letterhead] in [Paper type].
Supported paper feeding tray Any input tray can be used.
Paper capacity
Make sure paper is not stacked higher than the
upper limit mark ( ) inside the tray. When using the
bypass tray, make sure paper is not stacked higher
than the paper guides inside it.
Paper Recommendations
111
To Next Page
Loading...
Need help?
General