Installing the Memory Expansion Units
This section describes how to install the memory expansion units.
Installing the SDRAM Module
• Do not touch the inside of the controller board compartment. It may cause a machine malfunction or
a burn.
• Before beginning work, ground yourself by touching something metal to discharge any static
electricity. Static electricity can damage the SDRAM module.
• Do not subject the SDRAM module to physical shocks.
• When installing the SDRAM module and wireless LAN interface board together, install the SDRAM
module first, and then install the wireless LAN interface board. If the wireless LAN interface board is
already installed, remove it before installing the SDRAM module.
• The printer comes equipped with 512 MB of memory. This can be expanded to a maximum of 1024
MB.
• Before using the new SDRAM module, you must configure settings in the printer driver.
1. Turn the printer off and unplug the power cord.
2. Remove the five screws securing the controller board.
The removed screws will be used to secure the controller board again later.
3. Holding the handle, carefully pull out the controller board.
Slide the controller board completely out and place it on a flat surface such as a table.
Installing the Memory Expansion Units
45
To Next Page
Loading...
Need help?
General