• Confirm that the SDRAM module was correctly installed by printing the configuration page. Check
that the total memory value is shown in "Device Connection" on the configuration page.
• The table below shows the total SDRAM module capacities.
Standard Extended Total
512 MB 256 MB 768 MB
512 MB 512 MB 1024 MB
• If the SDRAM module was not installed properly, repeat the procedure from the beginning. If it cannot
be installed correctly even after reattempting installation, contact your sales or service representative.
• For information on printing the configuration page, see "List/Test Print Menu", Software Guide.
• Install the controller board carefully. For details, see "Cautions When Re-installing the Controller
Board".
• To use the installed SDRAM module, configure the printer options in "Change Accessories" in the
printer driver. For details about opening "Change Accessories", see "Making printer default settings
- the printer properties", Software Guide.
• p.35 "Cautions When Re-installing the Controller Board"
Installing the Hard Disk
This section explains how to install the hard disk in the basic model.
A hard disk is pre-installed in the HDD standard model.
2. Installing Options
48
To Next Page
Loading...
Need help?
General