SD CARD APPLI MOVE
SM 5-109 G104
Service
Tables
5.4.3 UNDO EXEC
The menu “Undo Exec” (SP5873-002) enables you to copy back application
programs from an SD card to the original SD card. You can use this program when,
for example, you have mistakenly copied some programs by using Move Exec
(SP5873-001). The application programs are copied as follows:
• From slot 2 to slot 3 when SD cards are
in slots 2 or in all slots
Note that the authentication data is also
copied with the application program (
5.4.1).
1. Turn off the main power switch.
2. Insert the original SD card in slot 3. The application program is copied back to
this card.
3. Make sure that the SD card (having stored the application program) is in slot 2.
The application program is copied back from this SD card.
4. Turn on the main power switch.
5. Enter SP mode.
6. Select SP5873-002 “Undo Exec.”
7. Follow the messages displayed on the operation panel.
8. Exit SP mode.
9. Turn off the main power switch.
10. Remove the SD card from slot 3.
11. Turn on the main power switch.
12. Check that the application programs run normally.
Keeping the SD card
After moving exe, the original SD card
must be kept in a secure place. Keep the
SD card in the area [A] as the drawing
shows and fasten it with a tape.
G105S906.WMF
G105S907.WMF
[A]
1 2 3
To Next Page
Loading...
Need help?
General
