Ricoh Interactive Whiteboard Controller Type 2 User Manual

Message Causes Solutions
Restart the whiteboard
Failed to switch the touch
input control.
The page will be restored
after restarting the
whiteboard.
Try again because the
function being performed
will be ended.
Do not turn the power off
while restarting.
Failed to switch the touch
input control.
Touch [Restart] to restart the
whiteboard.
An error has occurred
Failed to switch the touch
input control.
The setting will be ended.
Try again because the
function being performed
will be ended.
Failed to switch the touch
input control.
Touch [OK] to close the "Administrator
Settings" screen. If you want to
continue configuring the setting,
reopen Administrator Settings.
Cannot login whiteboard Failed to communicate with
the server.
The following are possible
causes:
• Cannot access the
network.
• The network settings
are incorrect.
• The server settings are
wrong.
Check the network settings and the
server settings. Also, check the network
status.
Cannot login whiteboard Failed to distinguish the user
(card) information.
• Check the user (card) information.
• Register the user (card)
information at the authentication
destination if necessary.
9. Troubleshooting
280

Ricoh Interactive Whiteboard Controller Type 2 Specifications

General

Brand	Ricoh
Model	Interactive Whiteboard Controller Type 2
Category	Controller
Language	English