Installation
Transport System Installation
182 MagneMotion
Rockwell Automation Publication MMI-UM007F-EN-P - September 2020
The locating features on the bottom of the motor can be used to aid in posi-
tioning.
Make sure that there is sufficient space around the motor mounting surface
for all connectors and for the bend radius of all cables.
2. Adjust the position of all motors to make sure that the motors are collinear to each
other and the space between motor bodies is consistent with the system layout.
3. Make sure that the tops of all motors are coplanar to each other (adjust the motor
mounts as required).
4. Tighten all QSHT motor mounting hardware to 4.8 N•m [42 in•lb] max.
NOTE: Make sure that the tip of the mounting bolt does not extend beyond the depth
of the mounting hole to prevent damage to the motor housing.
See the engineering drawings for the locations, depths, and torques for all
mounting features.
5. Verify that all motors are properly mounted and the Motor Gap between all motors is
identified and recorded. Make sure that the top surface of all motors are coplanar to
each other, all vehicle guides are collinear, and all motor mounting bolts are tightened.
NOTE: The Motor Gap must be entered for the motors in the Node Controller Con-
figuration File. If all motors on a path have the same Motor Gap, it can be
entered once in the Motor Defaults before defining the individual motors on
the path (see the QuickStick Configurator User Manual, MMI-UM009).
To Next Page
Loading...
Need help?
General
